tud Generator Speed Control Utilizing Hydraulic Displacement Units in a Constant Pressure Grid for Mobile Electrical Systems 2016-05-03 [Electronic ed.] 4519974-7 Saechsische Landesbibliothek- Staats- und Universitaetsbibliothek Dresden prv Saechsische Landesbibliothek- Staats- und Universitaetsbibliothek Dresden, Dresden Fakultät Maschinenwesen Institut für Fluidtechnik Professur für Fluid-Mechatronische Systemtechnik male male male Liebherr mobile harbor cranes use electrical generators to provide electrical power for load attachment devices such as container spreaders or magnets. Upcoming exhaust and noise emission standards and energy saving considerations lead to a broad diesel engine speed range. The challenging design aspect is to ensure a constant speed of the asynchronous generator by the hydraulic drive system. In addition, electrical load profiles of inductive consumers usually have DT1 system characteristics with very small time constants. They evoke fast torque variations interfacing the hydraulic transmission. Liebherr mobile harbor cranes, see Figure 1, usually have a closed hydraulic circuit containing a hydraulic pump with a high displacement volume that is adjusted electronically in accordance to the current diesel engine speed. Regarding the energy saving aspects, a further minimization of the diesel engine speed leads to a larger pump size with increasing torque losses. Depending on the pressure setting, the volume flows can be reduced in constant pressure grids. Especially in part-load operation this results in better efficiency compared to closed hydraulic circuits by minimizing the displacement volume of hydraulic components. To obtain a stable generator speed, it is essential to adjust the displacement volume of the hydraulic unit for equalizing its input torque with the Figure 1: LHM 800 Group 10 - Mobile Hydraulics | Paper 10-5 199 generator load torque. In interaction with the software-based control architecture, the stability of the electrical frequency depends on the mass inertia of the generator drive and time constants of the embedded hydraulic actuators. The system model, represented by ODEs is established and verified with a hydraulic simulation software. On that basis, the design approach of a PI-state-controller is presented. Corresponding controller gains and state feedback parameters are determined by pole placement techniques. To conclude this investigation a comparison between the hydraulically closed circuit and the constant pressure grid is shown by simulation and measurement data. 620 ZQ 5460 Mobile hydraulics, displacement control, control design urn:nbn:de:bsz:14-qucosa-200484 Dresdner Verein zur Förderung der Fluidtechnik e. V. oth Dresdner Verein zur Förderung der Fluidtechnik e. V., Dresden Technische Universität Dresden pbl Technische Universität Dresden, Dresden Thomas Dötschel aut Michael Deeken aut Klaus Schneider Dr.-Ing. aut eng 2016 1 urn:nbn:de:bsz:14-qucosa-197655 199 qucosa:29251Volume 3 – Conference: Thursday, March 10 10th International Fluid Power Conference (10. IFK) March 8 - 10, 2016, Vol. 3, pp. 199-210 born digital Tobias Schulze 035146342603 schulze@ifd.mw.tu-dresden.de in_proceeding