ubc Spectroelectrochemistry of self-assembled monolayers of 2- and 4-mercaptopyridines Spectroelectrochemistry of self-assembled monolayersof 2- and 4-mercaptopyridines 2007-07-10 [Electronic ed.] prv Universitätsbibliothek Chemnitz Universitätsbibliothek Chemnitz, Chemnitz Fakultät für Naturwissenschaften female Alexandria , Ägypten male male male male Die Elektrochemie und die Spektroelektrochemie von selbst-organisiererten Monoschichten (selfassembled monolayers, SAMs) gebildet aus 2-Mercaptopyridin (2MP) und 4-Mercaptopyridin (4MP) wurden an polykristallinen Goldelektroden in wässrigen Elektrolytlösungen untersucht. Folgende Untersuchungsmethoden wurden angewandt: zyklische Voltammetrie, elektrochemische Impedanzmessungen (EIM) und oberflächenverstärkte Raman Streuung (surface-enhanced Raman scattering, SERS). Die elektrochemischen Untersuchungen von 2MP und 4MP in wässriger saurer Lösung (0.5 M H2SO4) zeigten, dass 2MP stärker adsorbiert wird als 4MP aufgrund der Bildung eines S-Au-N Chelates, wobei die S-Au-Interaktionen bei 4MP stärker sind. Die Bildung eines Chelates im Falle von 2MP verringert die Wahrscheinlichkeit der Bildung eines Dimers. In sauren Lösungen wird das N-Atom von 2MP protoniert, was zu einer schwächeren Bindung von 2MP-Molekülen zur Substratoberfläche führt. Die Ergebnisse der SERS-Untersuchungen stimmen mit den Resultaten aus der zyklischen Voltammetrie überein. Man erhält eine Au-S-Streckschwingungsbande für 2MP zwischen 225 bis 250 cm-1 bei Abscheidung aus wässriger oder saurer Lösung und für 4MP bei ca. 263 cm-1 in beiden Lösungen. Die SERS-Experimente ergaben eine senkrechte Orientierung zur Goldoberfläche sowohl für 2MP als auch für 4MP. Die Thion-Thiol-Tautomerie von 2- Mercaptopyridinen wurde ebenfalls in Betracht gezogen. Die Unter- und Überpotentialabscheidung von Kupfer auf einer polykristallinen Goldelektrode in wässriger 0.1 M Schwefelsäure in An- und Abwesenheit von SAMs von 2- und 4- Mercaptopyridin wurde mit zyklischer Voltammetrie untersucht. Es zeigte sich, daß bei Vorhandensein der SAMs die Elektrodeposition von Kupfer verhindert wird, was auf starke Wechselwirkungskräfte zwischen dem Adsorbat (MP) und der Goldoberfläche zurückzuführen ist. 2MP zeigt eine grössere Inhibierung, was höchstwahrscheinlich auf die Bildung der Chelatstruktur zurückzuführen ist. Es wurden ebenso Untersuchungen zum Einfluss von 2MP und 4MP auf die abgeschiedene Kupfermonolage auf der Goldelektrode durchgeführt. Es zeigte sich, daß die Kupfermonolage teilweise durch 2MP oder 4MP ersetzt wird. Die Elektronenaustauschgeschwindigkeit für das Fe2+/Fe3+-Redoxsystem in An- und Abwesenheit von 2MP- oder 4MP-Monolagen wurde mit zyklischer Voltammetrie und elektrochemischen Impedanzmessungen (EIM) untersucht. Es stellte sich heraus, dass der Elektronenaustausch höchstwahrscheinlich über Defektstellen in der Monolage (Pinholes) erfolgt. In einer wässrigen Lösung verringert 4MP den Elektronenaustausch stärker als 2MP. Da die Packungsdichte bei 4MP größer ist als bei 2MP ist wahrscheinlich auch die Zahl der Pinholes geringer in der 4MP-Monolage. In saurer Lösung liegen die N-Atome protoniert vor. Man kann davon ausgehen, dass in saurer Lösung zwei Prozesse gleichzeitig ablaufen, die für den Elektronenaustausch entscheidend sind. Erstens kommt es zu einer Abstoßung zwischen der positiv geladenen Monolage und den positiv geladenen Redoxionen. Und zweitens erfolgt eine Abstoßung zwischen den positiv geladenen Molekülen der SAMs, was zu einer geringeren Packungsdichte führt. Der Ladungsaustausch wird dominiert durch den zweiten Effekt. Mit Hilfe von EIM wurden die Elektronenaustauschgeschwindigkeit und der Bedeckungsgrad bestimmt. Die korrosionshemmende Wirkung von 2MP und 4MP auf Stahl in 3.5 % wässriger NaCl-Lösung wurde mit Hilfe der EIM untersucht. 2MP zeigte eine grössere Hemmung als 4MP. The electrochemistry and spectroelectrochemistry of the self-assembled monolayers (SAMs) prepared of 2-mercaptopyridine (2MP) and 4-mercaptopyridine (4MP) dissolved either in water or 0.1 M H2SO4 have been investigated at polycrystalline gold electrodes in aqueous electrolyte solutions using cyclic voltammetry, electrochemical impedance measurements (EIM) and surface enhanced Raman spectroscopy (SERS). Electrochemical studies of 2MP and 4MP monolayers in aqueous acidic solution (0.5 M H2SO4) suggest that 2MP is adsorbed more strongly than 4MP due to the formation of S-Au-N chelate. However, the S-Au bond was found to be stronger in 4MP as compared with 2MP. The formation of the chelate in case of 2MP diminishes the probability of dimer formation. In the acidic solvent, the N-atom of 2MP molecule will be protonated leading to a weaker interaction of 2MP molecules with the substrate surface. The SERS results are in good agreement with the cyclic voltammetry results. The Au-S stretching band was obtained in the region from 215 to 245 cm-1 for 2MP deposited from water and acidic solvent and around 263 cm-1 for 4MP in both solvents. The SERS measurements showed also a perpendicular orientation of both 2MP and 4MP on the gold surface. In explaining the SERS results, the thione-thiol tautomerisations of the mercaptopyridines were also taken into consideration. The under- and overpotential deposition of copper on a polycrystalline gold electrode in aqueous 0.1 M sulfuric acid in the presence and in the absence of SAMs of 2- and 4-mercaptopyridine has been studied using cyclic voltammetry. In general, the presence of these SAMs has been found to inhibit the electrodeposition process of copper, suggesting very strong interactions between these adsorbates and the Au surface. 2MP shows a higher degree of inhibition, which is due to a stronger interaction probably due to the formation of the chelate structure. Studies have also been made of the influence of mercaptopyridines SAMs on the copper monolayer electrodeposited on the gold surface. The copper adlayer was found to be partially displaced by 2MP and 4MP monolayers. The rate of electron transfer for the Fe3+/2+ redox system on the gold electrode has been probed in the absence and presence of 2MP and 4MP monolayers by cyclic voltammetry and electrochemical impedance measurements (EIM). The charge transfer process was suggested to occur through the defects (pinholes) in the monolayer. In case of aqueous solvent 4MP decreases the electron transfer reaction stronger than 2MP. Since the packing density for 4MP is higher than that of 2MP the number of pinholes might be lower in 4MP monolayer. In acidic solvent the N-atoms of the mercaptopyridines will be protonated. It is proposed that two effects, which exist at the same time, are responsible for the electron transfer process in acidic solution. First, there will be a repulsive interaction between the positively charged monolayer and the positively charged redox probe. Second, there is a repulsion among the positively charged monolayer molecules that results in a less compact monolayer. The charge transfer is dominated due to the latter effect. With the EIM the rate of electron transfer and the surface coverage were determined. 2MP and 4MP were examined as steel corrosion inhibitors in 3.5% aqueous NaCl solution using EIM. 2MP shows higher inhibition efficiency than 4MP. 540 Elektrochemie Elektronentransfer Korrosionsinhibierung Spektroelektrochemie 2- und 4-Mercaptopyridin Corrosion inhibition Cyclic Voltammetry Electrochemical impedance measurements Electrochemistry Electron transfer Self-assembled monolayers Spectroelectrochemistry Surface enhanced Raman spectroscopy Zyklische Voltmmetrie selbst-organisierende Monoschichten urn:nbn:de:swb:ch1-200701123 Technische Universität Chemnitz dgg Technische Universität Chemnitz, Chemnitz Nazly Hassan 1968-03-12 aut Rudolf Holze Prof. Dr. dgs rev Alexander Auer Dr. rev Andreas Bund Dr. rev eng 2007-01-25 2007-06-20 born digital doctoral_thesis