ubc Viskosität metallischer Schmelzen und deren präzise Messung 2001-09-24 [Electronic ed.] prv Universitätsbibliothek Chemnitz Universitätsbibliothek Chemnitz, Chemnitz Fakultät für Naturwissenschaften Diese Arbeit berichtet über die Planung und den Aufbau eines neuen Viskosimeters und über Viskositätsuntersuchungen einiger metallischer Systeme. Diese letzteren Messungen wurden mit einem vorhandenen Viskosimeter gemacht, in dem kein besseres Vakuum als 10^(-3)mbar und keine höhere Temperatur als 1430K erreicht werden kann. Das beste Vakuum und die maximale erreichbare Temperatur in dem neuen Viskosimeter sind 10^(-6)mbar bzw. 1870K. Diese beiden Grundbedingungen ermöglichen die Viskositätsmessung metallischer Systeme, die aktive Elemente wie Al, Mg und P enthalten oder/und einen höheren Schmelzpunkt besitzen. Mit dem Drei-Zonen-Ofen erlaubt die neue Apparatur auch ein schnelleres Homogenisieren der zu untersuchenden Schmelze, besonders der monotektischen Systeme. Der Einfluß der Temperatur des Torsionsdrahtes und der Anfangsphase der Schwingung auf die Genauigkeit der Viskostätsmessung wurden analysiert und entsprechende Verbesserungen vorgeschlagen. Die untersuchten Systeme sind das Zn-Pb basierte ternäre System, die monotektischen Systeme Ag-Te und Li-Na, das Verbindungssystem Sb-Zn, die halbleitenden Cd-Te Legierungen und Schaummaterialien ZACT und ZACM. Viscosity of metallic melts and its precise measurement This thesis reports the design and the construction of a new oscillating cup viscometer and the viscosity investigation of several metallic systems. The measurements were carried out with an existing viscometer by which one could not get better vacuum than 10^(-3)mbar or higher temperature than 1430K. With the new apparatus the best vacuum of 10^(-6)mbar and the highest temperature of 1870K can be reached. These two basic conditions permit the measurement of systems which contain active elements such as Al, Mg and P and/or have very hight melting points. The construction of the three-zone furnace in the new viscometer allows the acceleration of the homogenising process, which is especially important for monotectic systems. The influences of the temperature of the torsion thread and the initial oscillating phase on the accuracy of viscosity measurement were analysed and the corresponding solutions were put forward. The investigated systems are the Zn-Pb based ternary system, the monotectic systems Ag-Te and Li-Na, the Sb-Zn system which contains compounds in the solid phases, the semiconducting Cd-Te alloys and the foaming materials ZACT and ZACM. 600 530 Flüssigkeit Viskosität Viskosimeter Entmischung Kritischer Exponent Kadmiumtellurid Schwingtiegelmethode Zink-Blei Silber-Tellur Antimon-Zink Lithium-Natrium Schaummaterial urn:nbn:de:swb:ch1-200100750 Technische Universität Chemnitz dgg Technische Universität Chemnitz, Chemnitz Changxing Dong aut ger 2001-09-24 2001-09-05 born digital doctoral_thesis